Buzzard Bombshell Electric Conversion and Mods

About a year and a half ago I picked up this wonderful high wing balsa old timer at a swap meet.  I did not know what it was but I'm a sucker for an inexpensive balsa old timer, especially a three channel high wing.  He wanted $25.  I offered $15.  He threw in a motor, esc, and two servos and we settled for the $25 he was asking!  I was a happy camper.

After some time and a bunch of Internet searching, I finally discovered that what I had bought was a plane called the Buzzard Bombshell.  The original design was done and built by Joe Konefes in 1940  with about a 72 inch wing span.  It was intended as a free flight as RC gear was way too expensive for most people.  This plane was designed to head up as high as so many ounces of fuel would take it and then glide for as long as possible (Joe flew his for over 49 minutes at the 1940 NATS).  To help with extended glide times they incorporated large tail surfaces that helped with lift and moved the CG to 50% or more back from the leading edge.  With the heavy motors of the time, this made for an interesting stubby nose look.

Mine was a more current and smaller version that was intended for 1/2A power sources.  It looks like it was setup for a Cox .049 judging from the mounting holes in the firewall.  Now by smaller I mean about a 45 inch wing span and still a good size plane.

Didn't realize that these cluttered photos were the only ones that I had at the time I posted this.

I'll take some better ones as soon as I get some time.

A couple of things that I really liked about this plane is that the builder did a pretty good job of construction and covering, but also, I see no oil residue and so don't think that a motor was run on this plane let alone even mounted.  I don't think it has ever been flown.

The first thing I looked at doing was to figure a motor mount

You can see here the holes for the original motor mount.  Fortunately the builder install blind nuts from the back side.  I just needed to figure out what size they are and how to go about using them.  They are oddly laid out so I can't directly use them and I'll need an adapter.

You can see the blind nuts in this photo.

I decided to use a circle of 1/8 inch plywood.  I would drill holes to line up with the engine mount holes and then drill holes to fit the electric motor mount.

I lined up the disk from the back side so that I could transfer the mounting holes from the front side.

Here is what I came up with.  I started counter sinking the holes so that I could use flat head screws so that it will fit flush against the firewall.

Here are the parts that I came up with to create my motor mount.  I ordered some aluminum stand offs from an online source and screws and washers from my local hardware store.  As I recall all of the threads turned out to be a standard 10-24.

Here is how the stand offs will fit with the electric motor x mount and the original motor mount.

This is how it would look with the longer stand offs.

Here is the new round plywood mount test fitted in place.

I needed to ream out the x mount slightly to fit the new screws.

Now the screws fit fine.

Here are the different stand offs and screws that I used.

Here is how it would look with the long stand offs.

This is how it would look with the short stand offs.  I like this look better, it puts the propeller closer to where it would have been with the originally designed gas motor.

I used different amounts of washers behind the x mount arms to set down and left thrust angles.

Here is the end result.

Now I need to start looking at where and how to mount the battery, ESC, and the two servos before I can get this thing back in the air.  These will be done in future updates.

Thanks for stopping by my blog.  Please feel free to post comments, good or bad, and be sure to come back and check for future posts.